Summary of Contents for Horizon Hobby Losi Eight mini
Page 1
1/14-scale Brushless truggy InstructIon Manual BedIenungsanleItung Manuel d’utIlIsatIon Manuale dI IstruzIonI Before operating this vehicle, please read all printed materials thoroughly. Horizon Hobby is not responsible for inadvertent errors in this manual.
NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-date product literature, visit horizonhobby.com and click on the support tab for this product. MEANING OF SPECIAl lANGUAGE The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product: NOTICE: Procedures, which if not properly followed, create a possibility of physical property damage AND a little or no possibility of injury.
Water-resIstant VehIcle WIth WaterProof electronIcs Your new Horizon Hobby vehicle has been designed and built with a combination of • Driving in wet conditions can reduce the life of the motor. The additional resistance of waterproof and water-resistant components to allow you to operate the product in many operating in water causes excess strain.
• Always inspect the battery before charging. • Read all safety precautions and literature prior to use of this product. • Always terminate all processes and contact Horizon Hobby if the product malfunctions. • Never leave the battery and charger unattended during use.
sPektruM dX2e radIo systeM 1. Steering Wheel Controls direction (left/right) of the model 2. Throttle Trigger Controls speed and direction (forward/brake/reverse) of the model 3. Antenna Transmits the signal to the model 4. ON/OFF Switch Turns the power ON/OFF for the transmitter 5.
srs4200 staBIlIty assIst receIVer control test AVC – ACTIVE VEHIClE CONTROl Perform a control test with the vehicle wheels off the ground. If the wheels rotate after the vehicle is powered ON, adjust the TH Trim knob until they stop. To make the wheels move The Spektrum SRS4200 receiver features Active Vehicle Control™...
fuze MInI Brushless WaterProof esc (dyn4840WP) ESC PROGRAMMING PROCEDURE 1. Power ON the transmitter and set the transmitter’s throttle endpoint travel to maximum B. Transmitter/ESC Endpoint Calibration and the throttle trim to the center position. After executing the setting task, the green LED will flash as you release the throttle trigger to neutral.
Motor wire solder joint is damaged Resolder the motor wire with the proper equipment Motor wire broken Repair or replace as needed ESC damaged Contact Horizon Hobby Product Support ESC gets hot Motor over-geared Use smaller pinion or larger spur gear Driveline bound up...
(iii) modification of or to any part of the Product, (iv) Service Request is available at http://www.horizonhobby.com/content/_service-center_render- attempted service by anyone other than a Horizon Hobby authorized service center, (v) service-center. If you do not have internet access, please contact Horizon Product Support Product not purchased from an authorized Horizon dealer, or (vi) Product not compliant to obtain a RMA number along with instructions for submitting your product for service.
Need help?
Do you have a question about the Losi Eight mini and is the answer not in the manual?
Questions and answers