Fax Errors - Canon PIXMA MX310 Service Manual

1-3. Fax Errors

For error other than those listed below, please refer to the "G3/G4 Facsimile Error Code List (Revision 2)
HY8-23A0-020."
(1) User error codes
Error code TX / RX
#001 TX
#003 TX / RX
#005 TX / RX
#009 RX
#012 TX
#017 TX
#018 TX
#022 TX
#037 RX
#085 TX
#099 TX / RX
#995 TX / RX
(2) Service error codes
Error code TX / RX
##100 TX
##101 TX / RX
##102 TX
##103 RX
##104 TX
##106 RX
##107 RX
##109 TX
##111 TX / RX
##114 RX
##200 RX
##201 TX / RX
##204 TX
Document jam
Document is too long, or page time-over
Initial identification (T0 / T1) time-over
Recording paper jam, or no recording paper
No recording paper at the receiving machine
Redial time-over, but no DT detected
Auto dialing transmission error, or redial time-over
Call failed (no dial registration)
Memory overflow at reception of an image
No color fax function supported in the receiving machine
Transmission terminated mid-way by pressing the Stop/Reset button
During TX (sending): Memory transmission reservation cancelled
During RX (receiving): Image data received in the memory cleared
Re-transmission of the procedure signal has been attempted the
specified number of times, but failed.
Sender's modem speed does not match the receiving machine.
Fallback is not available.
EOL has not been detected for 5 seconds (or 15 seconds in CBT).
RTN or PIN has been received.
The procedure signal has been expected for 6 seconds, but not
received.
Fallback is not available at the sending machine.
After DCS transmission, a signal other than DIS, DTC, FTT, CFR, or
CRP has been received, and re-transmission of the procedure signal
has been attempted the specified number of times but failed.
Memory error
RTN has been received.
A carrier has not been detected for 5 seconds during image
reception.
DCN has been received in a method other than the binary procedure.
DTC has been received even when there is no sending data.
(6/32)
Meaning
Meaning