NanoXX 9500HD User Manual page 19

C
hapter 5 >> Main Menu
2 Set the following options to complete Manual Scanning.
 Satellite:
Select a satellite by using the Arrow (▲/▼ ◄/►)
buttons or Page (+/-) buttons.
 Transponder:
Set the transponder for the selected satellite.
Select a transponder using the Arrow (◄/►) buttons.
If you cannot find your desired transponder, select New
to change transponder information as follows:
• Frequency
Display the selected TP Frequency.
• Symbol Rate
Display the selected TP Symbol Rates.
• FEC (Forward Error Correction)
Select a FEC option Auto, 1/2, 2/3, 3/4, 5/6, and 7/8 using the Arrow buttons.
• Polarity
Select a polarity value among Horizontal, Vertical, Circular Left, and Circular Right
using the Arrow buttons.
• Horizontal output is 18V and Vertical output is 13V via LAN.
Note
• What is transponder?
A wireless communications device usually attached to a satellite. A transponder
receives and transmits incoming signals with in a prescribed frequency range. After
receiving the signals the transponder will broadcast those signals with different
frequencies.
 Scan Mode
Decide whether to find free channels only or all the channels including scrambled ones.
Select a scan mode using the Arrow (◄/►) buttons.
• All: Scans all types of channels.
• Free: Scans free channels only.
 NIT Search
You will be asked whether to search channels for another transponder.
Select either Yes or Off using the Arrow (◄/►) buttons.
Select Yes to run Network Search.
 PID Search
You can manually scan channels by entering individual Packet Identifier (PID) values.
Enter the PID the Numeric (0~9) buttons.
First, select a PID type (Video PID, Audio PID, or PCR PID) using the Arrow (◄/►)
buttons, then enter the PID value by pressing the Numeric (0~9) buttons.
3 Press the OK button, then starts scanning.
After Auto Scanning is complete, you can see TV and Radio channels found from Auto
Scanning.
English
20