Table of Contents
Advertisement
C
hapter 5 >> Main Menu
M
ain Menu
The menu has been carefully designed from user-friendly point of view to assure easy operation
to your receiver. The main menu is classified into 7 sub menus that will carry out the various
operations individually.
Installation
In the Installation menu, you can customize antenna setting and do channel scanning.
Press the Menu (
) button.
Select Installation using the Arrow (◄/►) buttons on the main menu.
Installation >> Antenna Setting
Antenna Setting
You can set antenna and LNB information for scanning channels. If antenna is not correctly set,
you cannot scan channels, therefore you cannot watch any
programs.
1 Select Antenna Setting using the Arrow (▲/▼) buttons
and press the OK button.
Antenna setting menu appears.
2 Select satellite for channel scan using the Arrow (▲/▼) or
Page (+/-) buttons and press the Arrow (◄/►) button to
select at option.
3 Select an option using the Arrow buttons.
LNB Power
Set LNB Power On.
Longitude
If you know the exact longitude of your location, use the Numeric (0~9) buttons.
Toggle between E (East) and W (West) using the Arrow (◄/►) buttons.
LNB Type(Unicable)
Select the LNB type by pressing Arrow (◄/►) button
- Universal 1 (9750 / 10600)
- Universal 2 (9550 / 10750)
- Unicable (1210 IF / 1420 IF / 1680 IF / 2040 IF)
• Select the Unicable and press OK Button to choose one IF by Auto detection
(When you use Unicable, Blind Scan function will be not supported)
- User Define (LNB Low / LNB high)
• LNB IF Frequency can be input with numeric key with RCU
- Standard (5150 / 9750 / 10000 / 10600 / 10750 / 11250 / 11300 / 11475)
Note
• What is Low Noise Block (LNB)?
The LNB is located at the satellite dish antenna. It amplifies the very weak received
satellite signal then converts the received microwave satellite signal so that the signal
may not decrease the gain between the dish and your receiver.
English
15
Advertisement
Table of Contents
