NanoXX 9500HD User Manual page 17

C
hapter 5 >> Main Menu
3 Press the RED (MoSAic) button to save selected satellites and then press the Back (
) button.
4 If you press the YELLOW (Audio) button, on-screen navigation menu is highlighted.
Use the Arrow buttons to move the motor to the west, east, north, and south in order.
Position of the motor can be restricted to the software
setting limits (West/East) using the RED (MoSAic) /
BLUE (SAT) buttons.
5 Press the YELLOW (Audio) button to highlight
Satellite.
• This function may not work depending on the type
of USALS program.
6 Enter the value of 000.0 E/W (latitude) and 000.0
N/S (Longitude) and then press the OK button on
the Go to X menu.
Motor changes its position according to the selected
satellite.
7 Confirm the Enable Limits/Disable Limits function
pressing the OK button. You will be prompted to
decide whether to use the West/East setting Limits setting value.
• This function may not work depending on the type of USALS program.
• Press OK in Go to Reference menu, the motor moves at zero longitude/latitude.
 Positioner
1 This function is used when receiving DiSEqC 1.2 Command with the adaptor that
controls positioner antenna. Select a satellite using the Arrow (▲/▼) buttons and
press the OK button. Satellite list appears. On the satellite list, you can select satellites
pressing the OK button. Press the RED (MoSAic) button to save the selected satellites.
2 If you press the YELLOW (Audio) button, on-screen navigation menu is highlighted. Use
the Arrow (▲/▼/◄/►) buttons to move the motor to the west, east, north, and south in
order. Position of the motor can be restricted to the software setting limits (West/East)
using the RED (MoSAic) / BLUE (SAT) buttons.
3 Press the OK button on the Go to satellite menu. Dish changes its position to the
direction of satellite.
4 Press the OK button on the Save Current Position menu. Current position of the
motor is saved according to the selected satellite.
5 Press the OK button on the Go to Ref. Position menu. Motor changes its position to
the zero longitude/latitude where the count begins. (this function is not supported by
the adaptor that controls positioner antenna)
6 Go to Reference changes the position of control adaptor.
7 Reset Positioner initializes the position of motor to the default value.
8 You can change the function Menu (Go to Ref. Position / Reset Position / Calculate
Positions) by using the Arrow (◄/►) button, activate the function with OK button
English
18