Board Installation Precautions
I
CAUTION
I
Two-board assemblies must not be installed in the
top slot directly under the top cover.
I
CAUTION
I
Do not use excessive force to seat boards in the
system slot connectors.
If excessive force seems to be needed to install a
board, remove the board, and inspect the system
slot connector for bent pins. Straighten any pins
that appear to be bent.
Remove the top cover and all boards above the
one that is difficult to seat.
Re-insert the board in the system slot connectors
and adjust the position of the board's connector to
mate correctly with the slot connector. Carefully
seat the board in the connector. Reinstall the
other boards the same way and the top cover.
16
Configuration