Installing The I/O Board; Removing The Optical Drive - Dell Latitude 14 Rugged Owner's Manual

Installing the I/O Board

1. Place the I/O board on the computer.
2. Tighten the scews that secure the I/O board to the computer.
3. Connect display assembly cable to the computer.
4. Connect the I/O cable to the computer
5. Tighten the screw that secures the I/O board.
6. Slide the I/O into its place on the computer.
7. Close the I/O bay press the latch door.
8. Install:
a. Bottom Cover
b. Optical Drive
c. Hard Drive
d. Battery
9. Follow the procedures in

Removing the Optical Drive

1. Follow the procedures in
2. Remove:
a. Battery
b. Hard Drive
c. Optical Drive
d. Bottom Cover
3. Perform the following steps as shown in the illustration:
a. Remove the screws that secure the optical drive connector to the computer [1].
b. Lift the connector upward direction [2].
c. Remove the screws that secure the connector to the computer [3].
After Working Inside Your computer
Before Working Inside Your Computer
27