DAELIM a.four Service Manual page 132

BRAKE SYSTEM
12-4
MASTER CYLINDER MASTER CYLINDER MASTER CYLINDER
MASTER CYLINDER MASTER CYLINDER MASTER CYLINDER MASTER CYLINDER
MASTER CYLINDER MASTER CYLINDER MASTER CYLINDER MASTER CYLINDER
MASTER CYLINDER MASTER CYLINDER MASTER CYLINDER MASTER CYLINDER
MASTER CYLINDER MASTER CYLINDER MASTER CYLINDER
FRONT CALIPER FRONT CALIPER FRONT CALIPER FRONT CALIPER FRONT CALIPER
FRONT CALIPER FRONT CALIPER
FRONT CALIPER FRONT CALIPER FRONT CALIPER FRONT CALIPER FRONT CALIPER FRONT CALIPER
FRONT CALIPER FRONT CALIPER FRONT CALIPER FRONT CALIPER FRONT CALIPER
HANGER PIN HANGER PIN HANGER PIN
HANGER PIN HANGER PIN HANGER PIN HANGER PIN
HANGER PIN HANGER PIN HANGER PIN HANGER PIN HANGER PIN HANGER PIN
HANGER PIN HANGER PIN HANGER PIN HANGER PIN
HANGER PIN
● If the brake bleeder is not used, do the following,
● First, fill the brake fluid up to the upper limit line.
● Connect the hose to the bleeder valve to receive brake
fluid.
① Squeeze the brake lever completely loosen the
bleeder valve 1/2 turn, and tighten it again.
·Do not release the brake lever unitl the bleeder valve
is tightened.
② Release the brake lever slowly to its fullest extent,
and leave it unattended for a few seconds.
③ Repeat the process specified in item ① and ②
until there is no more air bubbles coming out of the
bleeder valve.
● Check the fluid level often, and add fluid if the fluid
level is near the lower level.
● If no air leaks out of the bleeder hose, operate the brake
lever to check the presence of air.
● Assemble the bleeder valve.
TORQUE : 0.6kgf·m
● Add brake fluid up to upper level. Install diaphragm
and mater cylinder cap.
TORQUE VALUE : 1.0kgf·m
BRAKE PAD REPLACEMENT
·When replacing brake pads, replace whole set.
·Do not remove the brake hose when replacing brake
pads.
● Loosen the hanger pin.