Installing On The Printer; Step 1: Install The Drying-Heater Unit - Roland SOLJET PROIII DU-740 User Manual

1-4 Installing on the Printer

Step 1: Install the Drying-heater Unit

WARNING Perform this task with all power switches left switched off.
Otherwise sudden movement of the machine may cause injury.
1.
Attach the arms.
–
Attach the arms.
Line up the tab and attach.
1. Loosely tighten the two upper locations.
2. Loosely tighten the location on the side where the orientation of the screw is level with the floor.
3. Fully tighten the two upper locations, then fully tighten the remaining location.
Tab
3 places
—
Right arm
3 places
Attach the bushing and cable clamp to the right
Cable clamp
arm.
Bushing
Tab
Chapter 1 Introduction 19