Using Transparent Media; Printing Hard-To-Dry Media - Roland SOLJET PROIII XC-540 User Manual

6-4 Accommodating Various Kinds of Media

Using Transparent Media

Procedure

MENU
SUB MENU

EDGE DETECTION
ENABLE

SETUP SHEET
ROLL
Description
This setting enables or disables detection of the leading and trailing edges of the media. It is normally
set to "ENABLE."
When transparent media is loaded, set it to "DISABLE." When this is set to "DISABLE," the "ROLL" and
"TU" selections are available during media setup. At this time, ensure a margin of at least 75 mm from
the leading edge of the media to the printing- or cutting-start location.
When [EDGE DETECTION] is set to "DISABLE," the machine cannot detect when media runs out. In such
cases, printing operation does not stop when the media runs out, and there is a chance that the platen
or the like may become soiled by ink or that ink may get inside and damage the machine. If media runs
out while printing is in progress, immediately press
Default Setting
[EDGE DETECTION]: ENABLE

Printing Hard-to-dry Media

Procedure

MENU
SUB MENU
Chapter 6 Feature Reference
94
Press
Press
Press
DISABLE
Use
Press
The settings are changed and the screen shown in
the figure appears.
Press
Press
.
several times .
twice.
to select "DISABLE."
to enable the setting.
to quit printing.
.
several times.