Roland SOLJET PROIII XC-540 User Manual page 123

5.
From the test pattern, read the correction value at the location.
Test pattern
Correction-value scale
Check the value on
the [FEED] side.
+2.0 +1.5 +1.0
-2.0 -1.5 -1.0
6.
Enter the correction value you read.

CROP - CUT ADJ.
SETTING

F :- 0.30
S : 0.00

CROP - CUT ADJ.
SETTING
Check the value on
the [SCAN] side.
+2.0
+1.5
+0.5
+0.0
SCAN
+0.5 +0.0
FEED
-0.5 -0.0
Press
Press
- 0.30mm
- 0.20mm
Use
[FEED SETTING].
Use
[SCAN SETTING].
Press
Press
6-7 Correcting Misalignment for Printing or Cutting
-2.0
-1.5
-1.0
Scan direction
-0.5
The point where the cutting line
intersects the correction-value
-0.0
scale is the correction value. In this
figure, the value is "-0.3." Use the
same method to read the value on
the [FEED] side.
Cutting line
.
.
to set the adjustment value for
to set the adjustment value for
to enable the setting.
.
Chapter 6 Feature Reference
Cutting line
-0.5
121