Table of Contents
Advertisement
Page 5
Item
Setting and values
(factory default settings shown by an asterisk)
a)
PB INH
Select whether or not to disable operation of
the ., B, and > buttons on the DSR-
DU1.
• ON: Disable.
• OFF*: Enable.
TALLY
Select whether or not to disable the recording
tally.
• OFF: Disable.
• ON*: Enable.
DELETE ALL
Delete all data from the hard disk.
A confirmation message appears.
ENHANCE
Select whether or not to display menu pages 6
and 7 (enhanced menu).
• OFF: Do not display.
• ON: Display.
a) Switching the i.LINK output takes several seconds. To avoid losing a
shooting opportunity because of the delay in switching to recording
after camcorder playback, it is recommended to set this to "ON." In this
case, the ., B, and > buttons on the DSR-DU1 are disabled.
Page 6
Item
Setting and values
(factory default settings shown by an asterisk)
CHECK DISK Check the hard disk for usability.
The meanings of indications showing the
result of CHECK DISK are as follows.
• "DISK: OK": The hard disk can be used.
• "DISK: NG": The hard disk cannot be
used.
• "B-PNT: XXX": A total of "XXX" bad
points (points where recording may not be
performed normally) have been detected.
When the CHECK DISK function ends, select
EXIT.
a) The CHECK DISK function takes about 3.5 hours. To inhibit recording
on all of the detected bad points, it is necessary to carry out the
DELETE ALL operation in menu page 5.
Page 7
Item
Setting and values
(factory defaults are unset)
SYSTEM
Video signal format. (Factory default is
unset)
• NONE: Unset
• 525U: NTSC. The date format is mm/dd/
yyyy.
• 525J: NTSC. The date format is yyyy/
mm/dd.
• 625: PAL. The date format is dd/mm/
yyyy.
DATE PRESET Switch to the screen for setting the date and
time (hh:mm:ss) preset values. Carry out the
operation with the jog dial.
a) The sequence for setting the date depends on the selected SYSTEM
setting.
Making Menu Settings
Use the following procedure.
1
2
3
4
a)
5
a)
Press the MENU button on the front panel.
The menu appears.
Turn the jog dial to select the desired page.
Press the jog dial.
It is now possible to select an item.
Turn the jog dial to select the desired item, and
press to confirm.
When "TC PRESET," "UB PRESET" or
"DATE PRESET" item was selected
In the screen for setting the preset value, turn the
jog dial to select the digit in the desired place, and
press to confirm. Next, turn the jog dial to change
the value and press to confirm.
After repeating these operations for all desired
places, select "SET" for preset value confirmation,
or select "EXIT" to cancel.
When the "DELETE LAST" or "DELETE
ALL" item was selected
A confirmation message appears. Select "OK" or
"EXIT."
Note
The PC REM, DELETE LAST, DELETE ALL, and
SYSTEM settings can only be set either
immediately after powering on the DSR-DU1, or
while it is in stop mode.
Turn the jog dial to select the desired setting, and
press to confirm.
When the "MODE" item is changed to
"DUP" or "INT"
A list appears, showing the other items which will
be changed. Select "OK" or "EXIT."
(After changing from "DUP" or "INT" to "STD," a
list appears of items which will be changed back to
their settings before selecting DUP or INT.)
23
Menus
Advertisement
Table of Contents
