Table of Contents
Advertisement
CTL set to ON, you can record on the DSR-DU1
coupled to the camcorder tape operations. To do
this, on the DSR-DU1 set the menu item
PARAREC to OFF.
4
Press the camcorder start/stop button.
Recording starts on the camcorder tape and the hard
disk of the DSR-DU1.
If the cache recording function of the DSR-DU1 is
on, the contents of cache memory are first written
to the hard disk.
5
Press the camcorder start/stop button.
Recording stops on the camcorder tape and the hard
disk of the DSR-DU1.
If the tape ends during recording
1
Press the EJECT button on the camcorder.
2
Change the tape.
3
Press the start/stop button on the camcorder.
The DSR-DU1 continues recording while you
change the tape.
Note
In the case of some camcorders such as the DSR-
PD100A/100AP and DCR-VX2000/VX2000E, if
several minutes elapse with no recording on the
tape (while changing tapes or while recording is
paused), the camcorder powers off.
Depending on the camcorder, when you change
tapes, the sound of the operation may be recorded,
or the i.LINK input to the DSR-DU1 may be
interrupted.
In DUPLICATE mode
In DUPLICATE mode, the hard disk is coupled to the
tape, and records the same audio, video, and timecode as
the tape.
Use the following procedure.
1
Power on the DSR-DU1.
2
In menu page 1, set MODE to DUP (see page 22).
3
Load a tape into the camcorder.
Notes
• If the camcorder is a model DSR-370/370P/
570WS/570WSP, set the camcorder menu item
i.LINK CTL to REC/P or ALL. (For more details
18
Operation
refer to the section of the camcorder operating
instructions describing the settings in the
advanced menu.)
To couple the operation of the DSR-DU1 to the
camcorder, set the VTR TRIGGER switch to INT
ONLY.
• If the camcorder is a model DSR-250/250P, set
the camcorder menu item EXT REC CTL to OFF.
(For more details refer to the camcorder operating
instructions.)
4
Press the camcorder start/stop button.
Recording starts simultaneously on the camcorder
tape and the hard disk of the DSR-DU1.
5
Press the camcorder start/stop button.
Recording stops simultaneously on the camcorder
tape and the hard disk of the DSR-DU1.
If the tape ends during recording
1
Press the EJECT button on the camcorder.
2
Change the tape.
3
Press the start/stop button on the camcorder.
The DSR-DU1 continues recording while you
change the tape.
Notes
• In the case of some camcorders such as the DSR-
PD100A/100AP and DCR-VX2000/VX2000E,
if several minutes elapse with no recording on the
tape (while changing tapes or while recording is
paused), the camcorder powers off.
Depending on the camcorder, when you change
tapes, the sound of the operation may be
recorded, or the i.LINK input to the DSR-DU1
may be interrupted.The cache recording function
does not operate.
• Depending on the camcorder, there may be a
discrepancy of a few frames between the DSR-
DU1 recording and the tape recording, at the
recording start point and end point.
• The timecode generator counting mode is
automatically set to EXT.
• In DUPLICATE mode, the playback function
does not operate.
Advertisement
Table of Contents
