Korg SV-1 Editor Manual page 51

S R
PRING EVERB
This models the spring reverb system used in some amps.
Parameters Values
Time 0...99
Lo Damp 0...100
Hi Damp 0...100
Pre Delay 0...70
Mix 0...100
T E
APE CHO
This models one of the most respected analogue tape echo machines ever made.
In the original, the "echo" is produced by a playback head and the exact "delay
time" is set by varying the motor speed. Many professionals prefer these "lo-fi"
units because of the warm, dark echoes they produce.
Parameters Values
Time 0...2700
Feedback 0...100
Tone 0...99
Lo Damp 0...100
Mix 0...100
The effects in detail | Reverb/Delay Effects section – 49
Notes
Sets the reverb time, which will differ depending on
the reverb type.
Adjusts the attenuation of the low-frequency range.
Adjusts the attenuation of the high-frequency range.
Sets the initial delay before the reverberation begins.
By adjusting this setting you can clarify the definition
of the original sound.
Adjusts the mix amount of the reverb.
Notes
Sets the delay time.
Adjusts the amount of feedback.
Adjusts the tone of the delay.
Adjusts the amount of low-frequency attenuation.
Adjusts the mix amount of the delay.