Installing The Flywheel And The Ignition Cover; Installing The Electric Starter - SHERCO 250 SE-R Workshop Manual

Reassembling the engine
❱❘ Installing the flywheel and the ignition cover
- Install the half moon in the slot in the crankshaft.
- Slide the flywheel on the crankshaft.
- Apply blue thread locker to the crankshaft threads.
- Install the nut and then install special tool 5207, tighten the nut to 60Nm.
- Install the two locating dowels.
- Install a new gasket and then install the ignition cover.
❱❘ Installing the electric starter
- Replace the starter O-ring with a new one.
- Apply a little grease to the O-ring.
- Install the starter in the right case.
- Attach the starter with two screws.
- Lubricate the clutch control shaft and insert it into the main shaft.
- Install the gear selector.
- Install the drain plugs using new seals.
CAUTION
Do not fill the gearbox with oil until the engine is installed in the frame as oil can spill out of the input shaft.
30
25
25
25
25
M6X...
25
25
30
39