Appendix: E-Sata Connection - Genie NVRX4 User Manual

9. Run the network client software.
10. Input Site Name, Site Address (IP address), Port No. and Password on the connect
window.
Site Name: Input a name that properly describes the site.
•
IP Address: Domain name or Public IP address of a router that NVRX is connected.
•
Port Number: Default Port Number is "5445".
•
ID: Input ID of NVRX. Default ID is "admin".
•
Password: Input network password of NVRX. Default Password is "1111".
•

APPENDIX: E-SATA CONNECTION

Please read the following instructions before using the E-SATA
port. Failure to do so may cause serious damage to the recorded
video. Genie is not responsible for data loss caused by improper
usage.
• Use ONLY a new HDD or a HDD that is approved for the unit.
• Turn off the NVR before plugging in the E-SATA HDD.
• DO NOT disconnect the E-SATA port while the NVR power is on.
• The purpose of the E-SATA port is to extend recording capacity.
• Once connected, DO NOT Remove or disconnect the E-SATA port from the NVR.
• The E-SATA port does not support the hot swappable function.
81