Table of Contents
Advertisement
8-1-4. Device
Select Device to set Enable/Disable CVBS Out, Motion Zone.
ALARM OUT: Set the sensor, motion, and video loss for triggering alarm relay. HDD
•
Error and Video Loss can trigger beeping.
SENSOR IN – LOCAL: Local Sensor input from 1 to 4.
o
SENSOR IN – IP CAM: IP Cam Sensor input
o
MOTION ON: Camera motion detection from 1 to 4.
o
DISCONNECTION : If the error occurs, an alarm output channel video set
o
HDD ERROR: HDD Failure alarm output
o
ALARM DURATION: Set alarm dwell time from 5 to 60 seconds.
o
BUZZER: Set the error type for the Buzzer activation
•
CHANNEL:
•
AUDIO SOURCE: Select IP CAM Audio or Local Audio
o
KEYTONE: Sets On or Off of Key Tone.
•
REMOTE CONTROLLER ID: Sets an ID number on the supplied remote control for its
•
identification.
SENSOR: Select the type of each sensor.
•
IEEE 802.3af PSE STATUS: PSE status Monitoring Menu
•
65
Advertisement
Table of Contents
