Back-Up Lamps; License Plate Lamp; Replacement Bulbs; Electrical System - Chevrolet 2013 Corvette Owner's Manual

10-44 Vehicle Care
4. Install the new bulb.
5. Reverse Steps 1 3 to reinstall
the license plate lamp assembly.

Replacement Bulbs

Exterior Lamp
Number
Back-Up Lamp
Front Parking/Turn
Signal 5702KA
Headlamp,
High-Beam Lamp
License
Plate Lamp
Stoplamp/Taillamp/
Turn Signal Lamp
For replacement bulbs not listed
here, contact your dealer.

Electrical System

Electrical System

Overload

The vehicle has fuses and circuit
Bulb
breakers to protect against an
electrical system overload.
3157K
When the current electrical load is
too heavy, the circuit breaker opens
and closes, protecting the circuit
until the current load returns to
normal or the problem is fixed. This
H9
greatly reduces the chance of circuit
overload and fire caused by
electrical problems.
194
Fuses and circuit breakers protect
power devices in the vehicle.
3057K
Replace a bad fuse with a new one
of the identical size and rating.
If there is a problem on the road and
a fuse needs to be replaced, the
same amperage fuse can be
borrowed. Choose some feature of
the vehicle that is not needed to use
and replace it as soon as possible.
I n f o r ma t i o n P r o v i d e d b y :
Headlamp Wiring
An electrical overload may cause
the lamps to go on and off, or in
some cases to remain off. Have the
headlamp wiring checked right away
if the lamps go on and off or
remain off.
Windshield Wipers
If the wiper motor overheats due to
heavy snow or ice, the windshield
wipers will stop until the motor cools
and will then restart.
Although the circuit is protected
from electrical overload, overload
due to heavy snow or ice may
cause wiper linkage damage.
Always clear ice and heavy snow
from the windshield before using the
windshield wipers.
If the overload is caused by an
electrical problem and not snow or
ice, be sure to get it fixed.