Taillamps, Turn Signal, And Stoplamps - Chevrolet 2013 Corvette Owner's Manual

Taillamps, Turn Signal,
and Stoplamps
To replace a stoplamp, taillamp/turn
signal bulb:
1. Remove the screw from the top
of the lamp assembly.
2. Tilt the lamp assembly
toward you.
3. Turn the bulb socket one-quarter
turn counterclockwise and pull
it out.
4. Pull the bulb straight out to
remove it from the socket.
5. Push the new bulb in the bulb
socket until it snaps into place.
6. Reinstall the lamp assembly by
first lining up the tabs on the
bottom of the lamp assembly
with the tabs in the vehicle, then
slide it in.
7. Replace the screw at the top of
the lamp assembly.
Back-Up Lamps
WARNING
Exhaust system parts can be very
hot. Do not touch them. If you do,
you can be burned.
1. Reach under the rear fascia and
locate the back-up lamp
assembly.
2. Remove the bulb socket by
turning counterclockwise and
pulling straight out of the lamp
assembly.
3. Pull the bulb out of the socket.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care
4. Install the new bulb in the bulb
socket.
5. Install the bulb socket by turning
clockwise.
License Plate Lamp
To replace one of these bulbs:
1. Remove the two screws (A) from
the license plate lamp
assembly (B).
2. Pull the lamp assembly down
and turn the bulb socket
counterclockwise and out of the
lamp assembly.
3. Pull the old bulb straight out of
the socket.
10-43