Chevrolet 2013 Corvette Owner's Manual page 165

Read the instructions completely
before attempting to program the
transmitter. Because of the steps
involved, it may be helpful to have
another person assist with
programming the transmitter.
Be sure to keep the original remote
control transmitter for use in other
vehicles, as well as for future
programming. Only the original
remote control transmitter is needed
for Fixed Code programming. The
programmed buttons should be
erased when the vehicle is sold or
the lease ends. See Erasing
Universal Home Remote Buttons in
this section.
Park the vehicle outside of the
garage when programming a garage
door. Be sure that people and
objects are clear of the garage door
or gate being programmed.
Programming Universal Home
Remote Rolling Code
For questions or help programming
the Universal Home Remote
System, call 1-866-572-2728 or go
to www.learcar2u.com.
Most garage door openers sold
after 1996 are Rolling Code units.
Programming a garage door opener
involves time-sensitive actions, so
read the entire procedure before
starting. Otherwise, the device will
time out and the procedure will have
to be repeated.
To program up to three devices:
1. Press START or put the vehicle
in accessory mode. See Ignition
Positions on page 9 17 for
additional information.
Programming can only occur
when the vehicle is running or in
accessory mode.
I n f o r ma t i o n P r o v i d e d b y :
Instruments and Controls
2. From inside the vehicle, press
the two outside buttons at the
same time for one to
two seconds, and immediately
release them.
5-61