Yamaha VK10W Supplementary Service Manual page 99

1 Fasten the passenger grip
warmer lead with the plastic
band, making sure that the end
of the band is on top of the pipe
and facing rearward. The plastic
band should not be visible when
the passenger seat is installed.
2 Route the passenger grip
warmer lead along the groove in
the storage compartment. Route
the passenger grip warmer lead
along the groove in the storage
compartment, making sure that
there is not excessive slack in
the lead.
3 Be sure to install the passenger
grip warmer switch with the "HI"
side up.
4 Position the coupler on the inside
of the storage compartment.
5 Fasten the tail/brake light sub-
wire harness with the plastic
band. (quantity: 7)
6 Pass the passenger grip warmer
lead through the hole in the
frame, routing it towards the
inside of the snowmobile, and
then pass the lead through the
hole in the storage compartment
before connecting it.
7 Connect the tail/brake light sub-
wire harness coupler on the out-
side of the storage compartment.
8 Tail/brake light sub-wire harness
9 Route the handlebar switch lead
on top of the sponge cushion that
is affixed to the frame.
0 Position the tail/brake light sub-
wire harness coupler in the loca-
tion shown in the illustration.
CABLE ROUTING
93
SPEC