Yamaha VK10W Supplementary Service Manual page 87

1 Right handlebar switch
2 Handlebar holder
3 Throttle cable
4 Pass all of the leads and cables
through the guide, except the
parking brake cable. Do not pass
the brake hose through the
guide.
5 Fasten the wire harness with the
plastic band.
6 Parking brake cable
7 Left handlebar switch
8 Starter cable. Pass the starter
cable over the left handle leads.
9 Speed sensor coupler
0 Lead cover
A Route the fuel tank breather
hose along the frame cross
member.
B Radiator fan motor coupler
C Fuel sender coupler
D There should be no slack in the
radiator fan motor lead.
E Fasten the relay lead, speed
sensor lead, and radiator fan
motor lead with the plastic band.
F Fasten the compression spring
section of the fuel tank breather
hose with the holder.
G Route the float chamber air vent
hoses behind the battery
bracket.
H Face the ends of the clamp
upward.
I Install the fuel tank breather hose
onto the breather pipe, making
sure that it contacts the running
board support.
J Back buzzer relay
K Passenger grip warmer relay
L Radiator fan motor relay
M To the speed sensor
N To the oil tank
O Negative battery lead
P To the parking brake
Q To the brake caliper
R Brake hose
S Fasten the wire harness with the
plastic band.
T Fasten the coolant hose with the
clamp.
U Fuel hoses
V Fasten the wire harness and the
fuel tank breather hose next to
the rubber damper on the frame
cross member with the holder,
making sure that the ends of the
holder are facing up.
W Fasten the fuel tank breather
hose with the holder.
X Fasten the wire harness with the
plastic band.
CABLE ROUTING
81
SPEC