1 Fuel pumps
2 Face the ends of each clamp
outward.
3 Fuel hoses
4 Coolant reservoir
5 Fasten the fuel tank breather
hose, speed sensor lead and
relay leads with the holder.
Secure the frame cross member
and the holder to the frame with
the nut and bolt.
6 Speed sensor lead holder
7 Rivet (quantity: 4)
8 Align the punch mark on the
bearing holder with the rivet.
9 Bearing holder
0 Speed sensor
A Front axle
B Primary sheave
C Water pump inlet hose
D More than 5 mm (0.2 in)
E Water pump
CABLE ROUTING
87
SPEC