Yamaha VK10W Supplementary Service Manual page 34

a
G
Ó
1
b
DRIVE CHAIN HOUSING
Ó 0 ~ 1 mm (0 ~ 0.039 in)
3. Install:
• Shift rod lock washer 1
NOTE:
Bend a lock washer tab along a flat side of the bolt.
4. Adjust:
• Shift rod length a
Adjustment steps:
• Adjust the shift rod length.
• Check that the shift lever pin moves smoothly
when the shift lever is pulled out 21 mm
(0.83 in) to the position b shown. Also, check
G
that the shift lever pin returns to its original
position by the force of the spring when the
shift lever is released. If the pin moves to a dif-
ferent position, adjust the shift rod length.
5. Fill:
• Drive chain housing oil
G
Refer to "DRIVE CHAIN" in CHAPTER 2.
6. Adjust:
• Drive chain slack
Refer to "DRIVE CHAIN" in CHAPTER 2.
28
POWR
TR
Shift rod length:
236 mm (9.29 in)