Scanner Cloning
If you have access to a compatible scanner that is
already programmed for your area, you can transfer
that scanner's programming using a standard stereo
patch cord (not included), terminated with 1/8" male
stereo plugs at each end.
The PRO-651 is compatible with the following
scanner models: PRO-106, PRO-197, PRO-651,
PRO-652, GRE PSR-500, PSR-600, Whistler
WS1040, and WS1065.
To clone a scanner:
1. Connect the two scanners at their PC/IF ports.
2. Turn on both scanners.
3. On the source scanner, press PGM.
4. Press the GLOB softkey.
5. Use the 4-direction keypad to locate the Clone
Send option.
6. Press SEL to transfer data.
NOTE: Working memory and global settings are
transferred but not V-Scanner folders. The target
scanner's working memory will be overwritten.
20
In some cases, the CCDump output may interfere
with cloning.
To turn off CCDump:
1. Press PGM.
2. Press FUNC and then the GLOB softkey.
3. Use the 4-direction keypad to locate the
CCDump option and change the setting.
4. Press the Save softkey.
Manual Programming
Modern radio systems can be complex and
challenging to program. If you choose to program
your scanner manually, refer to the "Manual
Programming Guide" on page 55.
21