Operation - Makita 2012NB Instruction Manual

Slip the heel of the set plate into the groove in the drum.
Install the blade installation bolts.
1
2
004471
After tightening all the blade installation bolts tightly and
evenly from the center to the outside, tighten them
completely following the same sequence.
1
2
004472
Install the other blade as described as above. Rotate the
drum slowly while pressing the lock plate to make sure
there is nothing abnormal. Then install the chip cover and
the side cover.
CAUTION:
Tighten the blade installation bolts securely when
•
installing the blades.
Do not turn the tool on with the chip cover open.
•
When installing the chip cover, make sure that the
•
chain is not caught by the chip cover.
Changing type of blade
This tool can accept either throw away blades or
standard blades. If you wish to change the type of blade,
buy and use the following parts.
Changing from standard blade
to throw-away blade
Set plate ---------------------- 2 pcs.
Throw-away blade (306 mm) --- 2 pcs.
Magnetic holder ---------------- 2 pcs.
006417
1. Set plate
2. Groove
3 3. Blade
4. Drum
4
1. Socket wrench
2. Lock plate
3. Blade installation
bolt
3
Changing from throw-away blade
to standard blade
Set plate ------------------ 2 pcs.
Pan head screw M 4 x 6 ----- 4 pcs.
Standard blade ------------- 2 pcs.
Blade gauge ----------------1 pc.
Hood set
004473
When you wish to maintain clean operations through
easy dust collection, connect the vacuum cleaner to the
thicknesser using this hood.
1
004474
Loosen the thumb screws which secure the chip cover.
Attach the hood to the thicknesser and secure the chip
cover and the hood together by tightening the thumb
screws.
CAUTION:
When installing the hood set, make sure that the
•
chain is not caught by the chip cover or hood set.

OPERATION

CAUTION:
Two or more pieces of narrow but similar thickness
•
stock can be passed through the thicknesser side
by side. However, allow some spacing between the
stock to permit the feed rollers to grip the thinnest
piece of stock. Otherwise, a slightly thinner piece
could be kicked back by the cutterhead.
004475
Place the workpiece flat on the table top.
Determine the depth of cut as described before.
8
1. Hood set
1
1. Thumb screw
2
2. Chip cover
3
3. Chain
4. Hood set
4