Water Reservoir; Installation - AEG PE-8038M Manual

Hide thumbs Also See for PE-8038M:
Table of Contents

Advertisement

The steam nozzle should be periodically cleaned. Preparing milk for cappuccinos
could dirty the inside of this nozzle. Therefore remove it as it is shown in the
figures above and wash with a sponge in warm water.
Attention: Before cleaning the steam nozzle, always switch the
machine off and wait for at least 20 minutes so that the steam pipe
can cool down. This will avoid the risk of scalding.
If the machine is not used for long periods, change the water in the reservoir
and drain the boiler by pressing the coffee button several times.
Clean the water reservoir periodically to scrape off any scale of limestone.
The water reservoir can be washed in a dishwasher.
When using the decalcifying Brita filter, replace it after approximately 2000 cups
of coffee or at least every six months.
This espresso machine is an appliance using water, therefore it is normal that
some scale of limestone can form in its boiler.
Then it is better to carry out the following operations every six months:
Fill up the water reservoir with 1.5 litres of water adding half a glass of vinegar
or citric acid.
Carry out the same operations as preparing some cups of coffee (refer to the
previous Chapter "Coffee"), but without ground coffee nor pods, so that only
water will flow out of the filter holder until the reservoir is completely empty.
Fill the reservoir again with cold water and repeat the above process (without
using coffee as before) to rinse the boiler.

15. INSTALLATION

Installing the machine into modular furniture with proper characteristics will ensure a
correct operation of the equipment.
Complying with the safety rules, ensure a proper protection against any contact with
the electric components and with the parts protected only by functional insulation,
by housing the machine correctly into the furniture.
All components that guarantee protection, even a cover panel (for instance, when
the machine is positioned at one of the ends of the modular furniture), should be
firmly fixed so that they cannot be removed without tools.
Install this machine at a certain distance from refrigerators or freezers, because the
heat it sends out can impair their functioning.
Downloaded from CoffeeMachineManual.com Manuals

WATER RESERVOIR

CLEANING CYCLE OF THE BOILER
HOUSING INTO MODULAR FURNITURE
29

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents