Cleaning The Water Inlet Filter; Cleaning The Drain Pump Filter - Daewoo DWD-F101(1~3) Manual

Cleaning the water inlet filter

Cleaning the water inlet filter
• "IE" error message will blink on the control panel when water does not enter the detergent drawer. • "IE" error message will blink on the control panel when water does not enter the detergent drawer.
• If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged. • If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged.
• It is therefore a good idea to clean it from time to time. • It is therefore a good idea to clean it from time to time.
1. Turn off the water tap.

Cleaning the drain pump filter

• The drain filter collects threads and small objects left in the laundry.
• Check regularly that the filter is clean to ensure smooth running of your machine.
CAUTION Be careful when draining if the water is hot.
1. Open the lower cover (1) by
using a coin.
Turn the drain cap (2) to pull
out the hose.
0 1 0
1. Turn off the
water tap.
3. Clean the filter
using a had
bristle brush.
2. Unplug the drain cap (2), allow-
ing the water to flow out.
At this time use a vessel to pre-
vent water flowing on to the floor.
When water does not flow any
more, turn the pump filter (3)
open to the left.
1
2
2. Unscrew the
water inlet
hose.
3. Remove any foreign material
from the pump filter (3).
After cleaning, turn the pump fil-
ter (3) clockwise and insert the
drin cap (2) to the orginal
place. Close the lower cover.
3
2
2. Unscrew the
water inlet
hose.
4. Tighten up the
inlet hose.
3
MAINTENANCE 9