While The System Is Sounding; Remote Panic Operation; Additional Remote Function ( Channel 2 ) - Prestige APS-25HT Owner's Manual

This action defeats the full trigger stage of the sensor and allows the pre-detect stage to
remain operational.
If within 3 seconds of arming the system, you press the arm button three times.
The siren will chirp 2 long beeps.
This action defeats both the pre-detect stage and the full detect stage of the sensor.
Once the system is disarmed, the sensor will return to normal operation upon the very next
arm cycle unless the above procedure is repeated.
If more than 3 seconds pass and then the arm/disarm button is pressed, the siren will chirp
2 short beeps, and the system will disarm.

WHILE THE SYSTEM IS SOUNDING

If during a triggered state, you wish to shut off the siren without disarming your security
system, simply press and release any transmitter button other than the disarm button. This
action will turn off the siren yet leave the vehicle fully armed and protected. This feature is
particularly useful if you are aware of children playing near your vehicle that may accidently
trigger your security system. In this case you can cancel the siren sounding without
disarming your alarm.

REMOTE PANIC OPERATION

The ARM or DISARM button on your keychain transmitter also functions as a panic switch for
use in emergency situations. To use remote panic,
1. Press and hold the ARM or DISARM button on the keychain transmitter for 3 or
more seconds. The alarm will immediately sound.
2. To stop the alarm, press and hold the ARM or DISARM button on the transmitter
again for 3 seconds. If the button is not pressed, the alarm will automatically
stop after 30 seconds. Also if any transmitter button other than the ARM or
DISARM button is pressed and released, the Panic mode will be turned off
immediately. The normal function of this transmitter button will be suspended
during the Panic sounding period.
3. During the panic mode, the Lock and Unlock buttons can be used to lock and
unlock the doors, (if the option is installed), however once the unlock/disarm
button is pressed, the vehicle's starter inhibit device, (where installed) will be
disabled allowing the vehicle to start.
NOTE: While in the Panic mode, pressing and releasing the ARM or DISARM buttons will, if
the option is installed, lock and unlock the doors respectively. While in the panic
mode, anytime the DISARM button is pressed, the panic feature will continue for the
allotted 30 seconds, however, the security system will be disarmed allowing the
vehicle to start.

ADDITIONAL REMOTE FUNCTION ( CHANNEL 2 )

This security system has an additional feature that can be connected to a number of different
optional accessories. Some of the more common uses for this channel are;
# Remote Trunk Release
Page 8