Using The Custom Code Override; Sensor Defeat From Transmitter - Prestige APS-25HT Owner's Manual

7. Within 10 seconds, begin to press and release the push button switch to set
the units digit.
(As per the example, press and release 2 times to set the units digit to 2).
8. Turn the ignition switch to the off position. Immediately observe the LED flash
pattern.
You will note the LED flashing five times, pause, and then flash two times, pause. This
pattern will be repeated three times indicating the new code (52) has been accepted and
stored in memory.
NOTE: If after step 8, the LED flashes a code other than what was just entered, this
indicates that the code has not been changed. You will have to repeat steps 1
through 7 above being certain to note the following:
Acceptable digits 10ths or units are 1 through 9. The unit will not recognize a 0 (Zero), or
no digit entered in any place, units or tenths.
NOTE: If 15 seconds of inactivity expire, or if the ignition switch is turned off for more then
5 seconds during any of the above steps, the unit will revert back to the last
successfully stored code.
MANUALLY OVERRIDING YOUR SYSTEM:

USING THE CUSTOM CODE OVERRIDE

Assuming the override code programmed has not been changed, and the default override
code of 11 is in the system's memory.
1) Enter the vehicle and turn the ignition switch to the on position.
NOTE: The siren will sound.
2) Within 5 seconds, press and release the pushbutton switch 1 time.
3) Within 5 seconds, turn the ignition switch off then on.
4) Within 5 seconds, press and release the pushbutton switch 1 time.
5) Turn the ignition switch off then on and start the vehicle.
NOTE: If you have changed the programmed override code then substitute your new
code tenths for step 2 above, and units for step 5 above.

Sensor Defeat From Transmitter

This system has the ability to allow the sensor to be defeated, from the transmitter, entirely
or in part for one arming cycle. To eliminate the sensor for one arming cycle:
Arm the system by pressing the arm button of the transmitter one time.
If within 3 seconds of arming the system you press the arm button one time.
The siren will chirp 1 short followed by 1 long beep.
This action defeats the pre-detect stage of the sensor and allows the full trigger stage to
remain operational.
If within 3 seconds of arming the system you press the arm button two times.
The siren will chirp 1 long followed by 1 short beep.
Page 7