Restoring Factory Settings In Computer Setup - HP EliteBook 820 G1 Maintenance And Service Manual

To exit Computer Setup menus, choose one of the following methods:
To exit Computer Setup menus without saving your changes:
●
Click the Exit icon in the lower-right corner of the screen, and then follow the on-screen
instructions.
– or –
Use the
press enter.
To save your changes and exit Computer Setup menus:
●
Click the Save icon in the lower-right corner of the screen, and then follow the on-screen
instructions.
– or –
Use the
press enter.
Your changes go into effect when the computer restarts.

Restoring factory settings in Computer Setup

NOTE:
Restoring defaults will not change the hard drive mode.
To return all settings in Computer Setup to the values that were set at the factory, follow these steps:
1. Turn on or restart the computer, and then press
message is displayed at the bottom of the screen.
2. Press
3. Use a pointing device or the arrow keys to select File > Restore Defaults.
4. Follow the on-screen instructions.
5. To save your changes and exit, click the Save icon in the lower-right corner of the screen, and
then follow the on-screen instructions.
– or –
Use the arrow keys to select File > Save Changes and Exit, and then press enter.
Your changes go into effect when the computer restarts.
NOTE: Your password settings and security settings are not changed when you restore the
factory settings.
136 Chapter 7 Computer Setup (BIOS)
key and the arrow keys to select File > Ignore Changes and Exit, and then
tab
key and the arrow keys to select File > Ignore Changes and Exit, and then
tab
f10 to enter Computer Setup.
esc while the "Press the ESC key for Startup Menu"
ENWW