IAdea XMP-320 Quick Start Manual

Download this manual

XMP-320/330 Media Player

Quick Start Guide

This printed quick guide provides a quick walkthrough of the set up process.

For complete documentation, please visit www.digisignage.com

Box Contents

AC Power Adapter

Standard 3.5 mm to

Ethernet Cable

Media Player Unit

12V DC output

RCA AV Cable

Wi-Fi Antenna

Quick Start Guide

CF card cover/remover

(XMP-330 only)

(this guide)

(pre-installed on unit)

USB Keyboard required

A USB keyboard is required to change system settings.

Mounting and Installation

The player can be attached to mounting posts on

the back of screens or inside cabinetry with the

built in VESA MIS-D100 (100mmx100mm)

compatible mounting flange

(For XMP-330 only)

ATTACH the wireless

antenna as shown.

Screw antenna

clockwise onto the post

Page 1: Quick Start Guide
XMP-320/330 Media Player Quick Start Guide This printed quick guide provides a quick walkthrough of the set up process. For complete documentation, please visit www.digisignage.com Box Contents AC Power Adapter Standard 3.5 mm to Ethernet Cable Media Player Unit 12V DC output...
Page 2 Port connections System setup ATTACH a video cable (either VGA or HDMI) to your monitor. → When using VGA, your monitor must support XGA (1024x768) resolution or greater. Connect audio using the included AV cable. → When using HDMI, audio and video are sent over a single HDMI cable. ATTACH the AC power adapter.
Page 3 WAIT while player boots up (up to 60 seconds) → once you see “Welcome” on screen, the unit is ready for content update or menu configuration PLUG IN a USB keyboard to the unit’s USB port → the player will enter the graphical menu system in approx. 30 sec. NAVIGATE the menus using your keyboard arrows (up), (down), (left), (right) to move the selection, (Space bar) to select, (Enter) to confirm, and (ESC) to...
Page 4: Troubleshooting
Content Management Please consult the software documentation for information specific to your management solution. Troubleshooting Why is there no video output on composite video connectors? The player outputs video over HDMI and VGA by default. To switch to composite video output, connect a HDMI or VGA display, then select PAL or NTSC output from the menu system (see System setup).

Xmp-330