Husky 80-GALLON STATIONARY AIR COMPRESSOR Use And Care Manual page 14

Installation - Electrical (continued)
2
Preparing the magnetic starter
□ Remove the magnetic starter cover by loosening the
screw (1), as shown. Use a Phillips screwdriver.
□ Lift the cover upwards from the bottom and off the base.
□ Set the cover aside until wiring is completed.
□ Familiarize yourself with these internal components of the
magnetic starter.
□ Refer to the illustration below to identify the
ground wire (2) from pressure switch, ground screw (3),
wires from pressure switch (4), wires from motor (5),
thermal overload (6), and terminal screws (7).
5
7
6
4
14
1
7
3
2