Assembling the air compressor unit
Never use plastic (PVC) pipe for compressed
air. Serious injury or death could result.
Never install a shut-off valve between the
compressor pump and the tank. Personal injury and / or
equipment damage may occur. Never use reducers in
NOTE: Do not overtighten. Over the life of the unit, you will
clean or replace the ﬁ lter as needed.
This air compressor unit can be installed as part of an air
distribution system. Any tube, pipe, or hose used in an air
distribution system must have a pressure rating higher than
175 psi. The minimum recommended pipe size is 3/4 in. Using a
larger diameter pipe is always better.
Use thread sealant tape on all the threadded connections of the air
compressor unit (A). This will prevent any air leaks between the
□ Screw the air ﬁ lter (B) onto the pump air intake.
□ Install the proviced reducer (BB) into the discharge port of
□ Attach the nipple (CC) to the reducer (BB).
□ Connect the shut-off valve (DD) to the nipple (CC).
Please contact 1-888-43-HUSKY for further assistance.