Table of Contents
Advertisement
Non-Adjustable Tubular Stands
Tubular stand mounting permanently attaches the unit to a
countertop or serving table. all wiring may be concealed within
one of the tubular stands.
Ensure safe and proper operation. Refer to the "Installation
Site Requirements" listed in the INSTALLATION section of
this manual.
aluminum, non-adjustable tubular stands are available in
heights of 10", 12", 14", and 16" (254, 305, 356, and 406 mm).
NOTE: Tubular stands cannot be retrofitted in the field.
NOTE: If wiring is to be concealed, a 1" (25 mm) diameter hole
must be provided in the mounting surface centered
under the stand containing the wire leads.
1"
(25 mm)
Distance from end of unit to center of conduit hole.
Needed for 1" diameter hole cutout in mounting surface.
Countertop Conduit Hole Dimension
1. Position the unit upside-down on a flat surface.
NOTE: Units for this application are supplied with the conduit
attached to one side of the unit. Conduit should not be
removed.
2. If applicable, route the flexible conduit through the center
of one of the stands.
3. Pull the conduit-side stand up against the unit and secure
the stand to the unit using the screws supplied. align the
other stand with the mounting holes at the other end of the
unit and secure the stand to the unit using the screws
supplied.
4. If applicable, route the flexible conduit through the 1"
diameter hole cut into the mounting surface.
5. Secure the stands to the mounting surface.
Form No. GRN4m-0312
CAUTION
OPTIONS AND ACCESSORIES
Non-Adjustable
Tubular Stand
Tubular Stand mounting
13
Mounting
Screw
Flexible
Conduit
Advertisement
Table of Contents
