The Right Upright (78). Insert An M10 X 96Mm - Pro-Form Crosswalk Sport 30324 User Manual

2. Remove the M10 Nut (33), the M10 x 50mm Bolt
(27), and the shipping bracket (C) from the Base
(85). Attach a Wheel (86) with the Bolt and the
Nut that you just removed. Do not overtighten
the Nut; the Wheel must turn freely. Discard
the shipping bracket.
Press a Base Cap (82) into the Base (85).
3. Identify the Right Upright (78) and the Right
Upright Spacer (80), which are marked with
"Right" stickers. Insert the Upright Wire (77)
through the Right Upright Spacer as shown. Set
the Right Upright Spacer on the Base (85).
Have a second person hold the Right Upright
(78) near the Base (85). See the inset drawing.
Tie the wire tie in the Right Upright securely
around the end of the Upright Wire (77). Then,
pull the other end of the wire tie until the Upright
Wire is routed completely through the Right
Upright.
4. Hold a Bolt Spacer (79) inside the lower end of

the Right Upright (78). Insert an M10 x 96mm

Bolt (5) with an M10 Star Washer (8) into the
Right Upright and the Bolt Spacer. Repeat this
step with a second Bolt Spacer (79), M10 x
96mm Bolt (5), and M10 Star Washer (8).
Hold the Right Upright (78) against the Right
Upright Spacer (80). Be careful not to pinch
the Upright Wire (77). Partially tighten the M10
x 96mm Bolts (5); do not fully tighten the
Bolts yet.
2
27
85
86
C
33
3
77
78
Wire
77
Tie
4
78
85
7
Tie
78
85
5
8
77
79
80
82
77
80
79