Enable Digital Zoom; Voice Communication - COMPRO TN900R User Manual

TN900R/TN900RW - User' s Manual

Enable Digital Zoom

To enable the digital zoom feature:
1. Click on the magnifier icon located on the lower-left corner of real-time video display, and then the digi-
tal zoom control window will pop up.
2. Check [Enable Digital Zoom] option and set desired zoom ratio by dragging the adjustment bar. Then set
the area to be enlarged by dragging the black square shown on preview window. Click on the [X] button
shown above or press [Esc] key to save the changes and/or close the preview window

Voice Communication

Pressing the [Communicate]
through the camera's speaker or audio line out. To talk through the external speaker connected to the IP cam-
era, place your cursor on the [Communicate] button (the tool tip "Right click to setup" will appear), and right-
click on the button and select [Setting] to choose input device and input source.
Having configured the device, please hit the [Communicate] button, (which then shall remain in "pressed"
status for 90 seconds and automatically be released later, unless it is hit again) and talk through the micro-
phone.
5-4 Voice Communication
Figure 5-2. Digital zoom window
button allows you to speak into your PC microphone and broadcast
Figure 5-3. Communication setting
Note:
When using the voice communication feature, you may experience
various degrees of delay between transmission from the computer
and playback on the camera end depending on the condition of your
network environment.