VIA Technologies P4MA PRO User Manual page 28

M
Power Button (PW_BN)
Connect to a 2-pin switch button. Pressing this button will turn the system
power on or off.
Reset Switch (RST_SW)
The Reset Switch is used to reboot the system rather than turning the power
ON/OFF. Avoid rebooting while the HDD is working. You can connect the
Reset Switch from the system case to this pin.
Power LED (PW_LED)
The LED is lit when the system is power on. If the system is in S1 (POS - Power
On Suspend) or S3 (STR - Suspend To RAM) state, the LED will blink.
HDD LED (HD_LED)
HDD LED shows the activity of a hard disk drive. Avoid turning the power off
while HDD LED is lit. Connect the HDD LED from the system case to this pin.
Sleep LED (SLP_LED)
The SLED is lit when the system is in the S1 (POS - Power On Suspend) state.
Speaker (SPEAKER)
The speaker from the system case is connected to this pin.
Pin Definition
PIN SIGNAL
1 PWR_LED+
3 PWR_LED+
5 PWR_LED-
7 SPEAKER-
9 NC
11 NC
13 SPEAKER-
15 NC
F_PANEL
2
1
2-15
Installation
PIN SIGNAL
2 HD_LED+
4 HD_LED-
6 PW+
8 PW-
10 RESET+
12 RESET-
14 SLED+
16 SLED-
16
15