Table of Contents
Advertisement
OFF
Disable the DOWNMIX and enable the 5.1ch function.
9.6.2. Configuring the Digital Output
1
Select the main menu item Audio Setup Page, then the
submenu item SPDIF Setup.
2
In the Digital Output Setup Page, select the sub-
menu item SPDIF Output.
3
Choose between the options ...
SPDIF Off
Select SPDIF Off if you have not connected any
digital audio components to the DVD player.
SPDIF/RAW
Select SPDIF/RAW if you have connected a multi-
channel digital audio component – such as a Dolby
Digital or DTS receiver or a 5.1 channel surround
sound system – to the DVD player via an optical or
coaxial cable.
SPDIF/PCM
Select "SPDIF/PCM" if you have connected a two-
channel digital audio component to the DVD player via
an optical or coaxial cable.
Manual
Select Manual if you would like to configure the above
settings separately for CDs, Dolby Digital, DTS and
MPEG and not have them apply generally. After you
have selected Manual: In the Digital Output Setup
Page, select the submenu items CD, Dolby Digital,
DTS and MPEG in turn. For each item, select one of
the options SPDIF Off, SPDIF/RAW, SPDIF/PCM
only. Then select the submenu item LPCM output.
Choose between the sampling frequencies 48 kHz and
96 kHz.
9.6.3. Configuring Prologic
1
Select the main menu item Audio Setup Page, then
the submenu item SURROUND.
2
In the 3D Processing Page, select the submenu item
ProLogic II.
3
Choose between the options ...
On
At the condition of DOWNMIX is setup to OFF, could
setup the PRO LOGIC II.When you select ON, it means that
2ch audio could be dummy as 5.1ch, multispeaker could be
hard such as VCDs, S-VCDs, MP3.
OFF
Select Off, it means that PROLOGIC II does not work.
Ô
On this topic, also refer to Section 9.6.9.1. "Confi-
guring the Speaker Sizes".
9.6.4. Configuring the Dynamic (Dolby
Digital)
To balance out the volume differences between loud
and soft passages during playback of Dolby Digital
sound:
1
Select the main menu item Audio Setup Page, then the
submenu item Dolby Digital Setup.
2
In the Dolby Digital Setup menu, select the subme-
nu item Dynamic.
3
Use the control buttons to set a value between Off
and Full.
9.6.5. Settings for Mono VCDs/S-VCDs
ô
Note:
These settings are only relevant for playing VCDs/S-
VCDs. The sound on VCDs/S-VCDs may be available as
Ú
1-language in stereo or
Ú
2-language in mono
1
In the Audio Setup Page, select the submenu item
Dolby Digital Setup.
2
In the submenu Dolby Digital Setup, select the
submenu item Dual Mono.
3
For mono VCDs/S-VCDs, select one of the options
...
17
Advertisement
Table of Contents
