Http Settings; Streaming Settings - D-Link DCS-5300 User Manual

Primary FTP
If the DCS-5300 is located inside a network that is protected by a firewall, a data connection for FTP may be prohibited. Passive
Passive Mode:
mode FTP can bypass this rule and allow the uploading of snapshots. If the passive mode is selected, the DCS-5300 can
automatically attempt to upload in active mode if the external FTP server does not support passive mode.
2nd FTP server:
The domain name or IP address of the external FTP server. Note that the 2nd FTP server will only be used if the 1st FTP is
unavailable. If image upload to the 1st FTP is successful, no attempts will be made to connect to the 2nd FTP server.
2nd FTP user
Granted user name on the backup FTP server.
name:
2nd FTP Granted password on the backup FTP server.
password:
2nd FTP remote
Granted folder on the backup FTP server.
folder:
Secondary FTP Passive mode setting for the backup FTP server.
passive mode:

HTTP Settings

HTTP Port:
Can be set to other than the default port 80. When the administrator changes the HTTP port of the DCS-5300 (which has
an IP address of 192.168.0.146) from 80 to 8080, users must type http://192.168.0.100:8080 in the Web browser bar.

Streaming Settings

Control channel
Can be set to other than the default port 5001 to correspond with the port opened by the firewall.
Port:
Audio channel Can be set to other than the default port 5002 to correspond with the port opened by the firewall.
Port:
D-Link DCS-5300 User Manual 35