Sony KL-X9200M Service Manual page 9

Stabilizing the monitor
Using the brackets
After setting up, secure the monitor to a wall, etc. with
the supplied brackets.
1
Mount the two supplied brackets with the
screws to the upper rear sides of the
monitor.
Bracket (supplied)
2
Pass a strong cord or a chain through each
bracket mounted in step 1, and then secure
it to a wall or a pillar, etc.
6 -GB
Getting Started
For customers in Japan and the U.S.
only
Using the support belts (not supplied)
You can also use the BLT-R10 support belt for the
monitor stand (not supplied) to secure the monitor.
We recommend you use the SU-90 monitor stand with
which the support belts are supplied.
About the SU-90 monitor stand (not supplied)
The dimensions of the stand are 1,050 x 700 x 630 mm
(41 3 / x 27 5 / x 24 7 / inches) (width/height/depth).
8 8 8
Before you purchase this stand, refer to the dimensions
above and check the size of the area where the stand
will be installed.
Customers in Japan should use the stand SU-90T.
Customers in the U.S. should use the stand SU-90U.
Rear
Front
Step 2: Hookup
Before making the connection, turn off the power and
disconnect the AC power cords of the monitor and the
equipment to be connected. Refer to the instruction
manual of the equipment you connect.
Connecting to an IBM PC/AT or
compatible computer
Connect the RGB 2 IN connector on the front or the
RGB 1 IN connector at the rear of the monitor to the
video output of the computer using the supplied RGB
signal cable (D-sub 15 pin ˜ D-sub 15 pin). Use an
audio connecting cord (not supplied) for the audio
connections.
Using the front RGB 2 IN connector
Front of the monitor
RGB 2 IN
S VIDEO
RGB AUDIO
RGB signal cable
(supplied)
or
Audio connecting
cord
(stereo miniplug ˜
stereo miniplug)
(not supplied)
HD15–HD15 adaptor
(supplied)*
Male side
(without the No.9 pin)
to video output to audio output
IBM PC/AT or compatible
computer
Using the rear RGB 1 IN connector
Rear of the monitor
RGB 1 IN
AUDIO RGB
R L
RGB OUT
AUDIO
RGB
R L
RGB signal cable
Audio connecting or
(supplied)
cord (phono plug
× 2 ˜ stereo
miniplug)
(not supplied)
HD15–HD15 adaptor
(supplied)*
Male side (without
the No.9 pin)
to audio output to video output
IBM PC/AT or compatible
computer
* The HD15–HD15 adaptor (supplied) may be needed for some
models. The male side (without the No. 9 pin) of the adaptor
should be connected to the computer.
For customers using the supplied HD15–HD15
adaptor
This monitor uses a No. 9 pin in the video signal
connector for DDC1 and DDC2B compatibility.
Some PC systems which are not compatible with either
DDC1 or DDC2B may not accept the No. 9 pin. If you
are not sure whether your PC system accepts the No. 9
pin or not, use the HD15 (Female) – HD15 (Male
without the No. 9 pin) adapter (supplied).
7
Getting Started
GB
-GB