Sony KL-X9200M Service Manual page 14

To turn off the monitor
Press 1/u on the remote control. The monitor enters
standby mode and the STANDBY indicator lights up.
To turn off the main power, press u switch on the
monitor.
Note
To protect the lamp, the picture and sound will not turn on
immediately if you try to turn on the power more than 5 seconds
after the power has been turned off. If you turn the monitor back
on within about 5 seconds after power-off, the picture and sound
will reappear immediately.
Muting the sound
Press MUTING on the remote control.
"MUTING" appears on the screen.
To restore the sound, press MUTING again, or press
VOL+.
Displaying on-screen information
Press DISPLAY on the remote control to display the
following information on the screen.
Current input
RGB 1
signal
fH: 37.5kHz
Current input signal
fV: 75Hz
frequency when
the RGB signal* is
input
*fH: Horizontal frequency
fV: Vertical frequency
"OUT OF SCAN RANGE" appears if the scanning
frequency range is not within the acceptable
limits. (See page 9.)
To make the on-screen information disappear, press
DISPLAY again.
16 -GB
Operations
Adjusting the
computer picture
Adjusting the position (CENTER)
After projecting the picture from a computer, you may
need to adjust the position of the picture to fit the
monitor screen. You can also move the picture as you
like. The setting is only for the input signal displayed
on the screen.
MENU ENTER
1
Press MENU.
MENU
2
Press v or V to select " (CENTER)," and
press ENTER.
C E N T E R
ENTER
EX I T
3
Press v, V, B or b to adjust the position.
For horizontal adjustment press B or b.
b: to move the picture right
B: to move the picture left
For vertical adjustment press v or V.
V: to move the picture up
v: to move the picture down
The CENTER adjustment screen automatically
disappears after about 80 seconds if you do not press
any button. You can also erase the CENTER adjustment
screen by pressing MENU.
To reset to the factory preset setting
Press RESET on the monitor while the CENTER
adjustment screen is displayed. For details, see page 26.
Notes
• You cannot use this function for the input from VIDEO 1/2/3
IN and COMPONENT IN.
• You can operate the menu using the √/◊/ı/∫ and the ENTER
buttons inside the drop-down panel on the front of the
monitor.
Adjusting the picture size (SIZE)
MENU ENTER
After projecting the picture from a computer, you may
need to adjust the picture size to fit the monitor screen.
The setting is only for the input signal displayed on the
screen.
1
Press MENU.
MENU
2
Press v or V to select " (SIZE)," and press
ENTER.
S I Z E
ENTER
EX I T
3
Press B or b to adjust the picture size.
b: to increase horizontal size
B: to decrease horizontal size
The SIZE adjustment screen automatically disappears
after about 80 seconds if you do not press any button.
You can also erase the SIZE adjustment screen by
pressing MENU again.
To reset to the factory preset setting
Press RESET on the monitor while the SIZE adjustment
screen is displayed. For details, see page 26.
Notes
• If a signal with resolution of 640 × 350, 640 × 400 or 720 × 400,
or Wide Resolution signal is input, the picture will be enlarged
to fill the screen but will appear lengthened vertically.
• You cannot use this function for the input from VIDEO 1/2/3
IN and COMPONENT IN.
• You can operate the menu using the √/◊/ı/∫ and the ENTER
buttons inside the drop-down panel on the front of the
monitor.
17 -GB
Operations
GB