Advertisement
Installation
Installing the door station
Be sure to install the door station on a flat, vertical wall.
Important:
L� O n the bottom surface of the door station, there is a hole to allow water to drain. Do not cover it up when installing.
1
Unscrew the Allen screw using the longer end of the Allen wrench and remove the mounting bracket from the rear of the
door station.
L� T he pin hole camera is not a screw to be touched or removed.
Pin hole camera
2
Attach the mounting bracket to the wall using the wood screws (3.8 mm x 20 mm).
L� B efore drilling, see page 4 for installation location.
Wood screws
3
Connect the wires that connect to the main monitor station to the terminal connector by unscrewing the screws, pushing in
the wires, then tightly fastening the screws.
L� S ee page 5 for the wire type and distance.
L� Y ou can change the camera angle using the camera angle control lever. See page 4 for details.
Terminal connector
(Non polar)
Screw
6
Allen screw
(Attached to the door station)
Allen wrench
Mounting bracket
Camera angle control lever
Wire (Not included)
Mounting bracket
83.5 mm
Wall
Wire (Not included)
Advertisement
