Installing The Door Station; Installing The Main Monitor Station - Panasonic VL-SW250BX Installation Manual

Installing the door station

Important:
LOn the bottom surface of the door station, there are holes to allow water to drain.
Do not cover them up when installing.
1
Remove the mounting base.
A Open the screw
cover.
TScrewdriver
2
Attach the mounting base to the wall securely using the wood screws (3.8 mm x 20 mm).
LInstall the mounting base on a vertical fl at wall.
LBefore drilling, refer to "Before installation" for installation location.
Wood screws
Mounting base
3
Adjust the camera angle using the camera angle control lever.
Rear view
Left
(maximum 15°)
<Examples of camera angle>
<Facing forwards> <Facing upwards>
Important:
LWhen the camera angle is adjusted to the upper left or upper right, the image may be slightly
distorted.
4
Connect the wire, then mount the door station to the mounting base.
A Unscrew the screws.
Push in the wire to the terminal connectors
(non polar), then tightly fasten the screws.
Wire (connecting to the main monitor station)
B Loosen the
mounting screw.
Water drain
Mounting base
holes
83.5 mm
Wall
Wire (Not included)
Camera angle
control lever
Right
(maximum 15°)
Upwards
(maximum 15°)
<Facing right> <Facing upper right>
LThe angle can also be adjusted to the left
or upper left.
B Mount the door station to
the mounting base.
C Fasten the screw, then
close the screw cover.

Installing the main monitor station

1
Attach the mounting bracket to the wall securely using the wood screws (4 mm x 16 mm).
LInstall the mounting bracket on a vertical fl at wall.
LBefore drilling, refer to "Before installation" for installation location.
Wood screws
Mounting bracket
2
Attach the wires connected to the door station to the terminal connector.
LConnect the wire correctly according to "Wiring schematic diagram".
LWhile pressing on the button with a pointed object such as a screwdriver, insert the wire into
the terminal connector. (To disconnect a wire, press on the button while pulling out.)
Button
Terminal
connector
Stripped end of
the wire
9 mm
3
Mount the main monitor station to the mounting bracket.
A Fit into position as shown in the fi gure.
B Push the main monitor station down until it is secure.
B
4
Connect the plug into an AC outlet (100 – 240 V AC).
To connect the plug to the power outlet which is not easily accessible
Important:
LIf you want to connect the plug to the power outlet which is in the wall or is not easily
accessible, install a main disconnect device near the main monitor station.
LUse a main disconnect device with minimum 3 mm contact spacing inside the device and
showing "ON" and "OFF".
To use an existing wire in your home
1 Be sure to turn off the power and confi rm that the wire type is CAT-3 (ø0.5) or 22 AWG
(ø0.65). If the wire type is not CAT-3 (ø0.5) or 22 AWG (ø0.65), change the wire to either of the
specifi ed wire types.
2 Install the main monitor station and the door station.
3 Turn on the power.
83.5 mm
Wall
Wire (Not included)
Wire from the door station
A