Advertisement
Installation
Before installation
To avoid malfunction or communication disturbances, do not install either the door station or the main monitor station in the
following locations:
– Places where vibration or any other kind of impact occurs.
– Places where echoing is frequent.
– Places near a high concentration of dust, hydrogen sulfide, phosphorus, ammonia, sulfur, carbon, acid, or noxious fumes.
– Within 2 m of a TV, microwave, personal computer, air conditioner or any other electrical device.
Standard installation position of the door station and camera range
Upper/lower range
LSide view of when the camera is facing the front at 0°.
Center of the
door station
46°
1450 mm
500 mm
N
Rear view of the door station
Note:
L� T he measurements and angles are for reference purposes and may vary depending on the environment.
L� I f a strong light is shining on the door station, the visitor's face may not be distinguishable.
Do not place the door station in the following locations.
– Where most of the background is the sky.
– Where the background is a white wall, and direct sunlight will reflect off it.
– Where direct sunlight will shine on the door station.
– Where echoing occurs, causing the unit to beep frequently.
L� Make sure the back of the door station is not subject to water.
Standard installation position of the main monitor station
Place the main monitor station in a location so that your eyes are the same height as the center of the display.
Note:
L� T his unit is using an electric wave frequency of 2.4 GHz. Read "For best performance" on the Operating Instructions.
L� I n areas surrounded by a high electrical field, disturbances may occur in the main monitor station's image or sound.
L� B e sure to install the main monitor station more than 5 m away from the door station.
L� D o not place any objects within 20 cm of the main monitor station. This may cause communication errors or malfunction.
L� D o not install the main monitor station inside a wall.
L� D o not install the unit in places where it will be affected by extremely high-frequency radio waves (near broadcasting
antennas etc.). This may cause the display to flicker or an interrupting noise to occur.
If you change to the Wireless Video Intercom System from chime, bell or buzzer
Existing wires (e.g. chime, bell or buzzer) may connect to power supplies (AC 100-240 V or 24 V).
If you connect the Wireless Video Intercom System through such existing wires, electric shock or unit damage may occur.
Contact the dealer where you purchased.
4
Image range:
425 mm
Camera angle control lever
Left/right range
LTop view of when the camera is facing the front at 0°.
Image range:
580 mm
L
500 mm
R
LTop view of when the camera is facing the left at 15°.
Image range:
650 mm
L
R
LTop view of when the camera is facing the right at 15°.
Image range:
650 mm
L
R
60°
Advertisement
