Defrost Control Assembly; Lamp; Refrigerator Compartment Lamp; Freezer Compartment Lamp - Kenmore 795.78773.801 Service Manual

* Ice Fan Scroll Assembly Replacement

1) Remove the plastic guide for slides on left side by
unscrewing phillips head screws.
2) Pull the grille forward as shown in the second picture.
3) Disconnect wire harness of the grille
4) Remove the scroll assembly by loosening
(1)
(3)

3-5 DEFROST CONTROL ASSEMBLY

Defrost Control assembly consists of Defrost Sensor and
FUSE–M.
The Defrost Sensor works to defrost automatically. It is
attached to the metal side of the Evaporator and senses its
temperature. At 72°C, it turns the Defrost Heater off.
Fuse-M is a safety device for preventing over-heating of
the Heater when defrosting.
1. Pull out the grille assembly. (Figure 10)
2. Separate the connector with the Defrost Control
assembly and replace the Defrost Control assembly
after cutting the Tie Wrap. (Figure 11)
GRILLE ASSEMBLY
Figure 10
screws
(2)
(4)
DEFROST-CONTROL
ASSEMBLY
Figure 11
- 9 -

3-6 LAMP

Unplug Refrigerator, or disconnect power at the circuit
breaker.
If necessary, remove top shelf or shelves.

3-6-1 Refrigerator Compartment Lamp

1) Release 2 screws.
2) Hold both ends with your both hands and pull it
downward to remove it.
3) Use a flat tool as shown below to remove
the cover lamp.
4) As shown below, use a flat tool to remove
the cover lamp.
Cover, Lamp

3-6-2 Freezer Compartment Lamp

1. Unplug refrigerator power cord form outlet.
2. Remove screw with driver.
3. Grasp the cover Lamp,pull the cover downward.
Figure 12
Figure 13
LED, Assembly
Case Lamp
Figure 14
Figure 15