Table of Contents
Advertisement
Temporarily secure the drying-heater unit.
Temporarily attach the drying-heater unit to the arms with two bolts each on the right and left sides.
Washer
Secure the drying-heater unit in place.
Raise the drying-heater unit to eliminate the gap between the unit and the printer, and completely tighten the four
bolts.
Secure in place
with no gap.
Drying-
heater unit
Arm
Two places
1-4 Installing on the Printer
Washer
Secure in place
with no gap.
Two places
Chapter 1 Introduction
19
Advertisement
Table of Contents
