What To Do If; The Drying-Heater Unit Doesn't Get Hot; The Blower-Fan Unit Doesn't Run; If A Message Appears - Roland DU2-64 User Manual

3-1 What to Do If

The Drying-heater Unit Doesn't Get Hot

Is the power cord connected?
Connect the power cord for the drying-heater unit securely.
 P. 23, "Connecting the Cables"
Is the drying-heater unit cable connected?
Connect the drying-heater unit cable to the printer unit.
 P. 23, "Connecting the Cables"
Is [OPTION DRYER] on the printer set to "ENABLE" as its value?
The drying-heater unit doesn't operate unless this is set to "ENABLE." Check the setting.
 P. 26, "What to Do First"
Is the power switch on?
Make sure the power switch is on.
 P. 26, "Switching the Power On and Off"
Is the temperature of the room too low?
Use the machine in an environment where the temperature is 20 to 32˚C (68 to 90˚F).

The Blower-fan Unit Doesn't Run

Is the blower-fan unit cable connected?
Connect the blower-fan unit cable to the printer unit.
 P. 23, "Connecting the Cables"
Is [BLOWER FAN] on the printer set to "ENABLE" as its value?
The blower-fan unit doesn't operate unless this is set to "ENABLE." Check the setting.
 P. 28, "Switching the Blower-fan Unit On"

If a Message Appears

[OPTION-DRYER IS NOT CONNECTED]
The unit is not connected correctly. Switch off the power to all devices, then check the connection to the unit.
 P. 23, "Connecting the Cables"
 P. 26, "What to Do First"
30
Chapter 3 Appendix