Table of Contents
Advertisement
STEP 3:
PREPARE THE VENTING BLOWER
Your microwave oven is shipped with the blower assembled for room-vented(recirculating).
You need to
adjust the blower if you want wall-venting or roof-vented installation.
WARNING
ELECTRICAL
SHOCK
HAZARD!
UNPLUG
UNIT BEFORE
WORKING
ON IT.
• DO NOT PULL OR STRETCH THE BLOWER WIRING! Pulling and stretching the blower wiring could
result in electrical shock.
REMOVE
THE MOUNTING
PLATE:
1. Remove any shipping materials and parts from
inside the microwave oven.
2. Cover the counter top or cooktop with a thick,
protective covering to protect it from damage and
dirt. See Figure 10.
NOTE: If you have a free-standing
range,
disconnect it, move it onto a piece of
cardboard or hardboard and pull it away
from the wall, so that you can get closer to
the upper cabinet and back wall for easier
measuring and drilling.
3. Remove mounting plate screw(s) (1 or 2 screws)
from the mounting plate as shown and discard.
(See Figure 11 .)
4. This plate will be used as the rear mounting plate.
(It will be used to locate and mark the mounting
holes on the rear wall.)
5. Locate exhaust adaptor, grease filters and
hardware packet.
6. At this point, remove any adhesive tape (if there is
any), on the exhaust adaptor, the grease filters
and the power supply cord.
A thick, protective
covering
_l___
Figure 10
L=
II
o
ji
!
I
o°
Mounting
plate
Mounting plate
screw(s)
(1 or 2 screws)
Control
panel
side
Figure 11
ROOM-VENTED
INSTALLATION:
Go to STEP 4 on page 13.
ml0m
Advertisement
Table of Contents
