Table of Contents
Advertisement
Prestigio Nobile 1560
2.
See "Removing the Middle Cover" on page 55
3.
See "Removing the Keyboard" on page 58 to lift up the keyboard, turn it over and put it on the upper case.
4.
Disconnect the two RF cables from the sockets on the wireless LAN board.
5.
Push out the latches on both sides of the socket, and then detach the wireless LAN board.
Removing the RTC Battery
1.
See "Removing the Battery" on page 51
2.
See "Removing the Middle Cover" on page 55
3.
See "Removing the Keyboard" on page 58 to lift up the keyboard, turn it over and put it on the upper case.
4.
Disconnect the RTC cable from the main board and remove the RTC battery from the upper case.
NOTE: Connect the RTC cable to RTC1 immediately and install the RTC battery back to the upper case to
prevent the CMOS from resetting.
Removing the LCD Module
1.
See "Removing the Battery" on page 51
2.
See "Removing the Middle Cover" on page 55
3.
See "Removing the Keyboard" on page 58 to lift up the keyboard, turn it over and put it on the upper case.
4.
Disconnect the inverter cable from the main board by using a plastic flat screwdriver and release the cable
from the latch as shown.
59
TECHNICAL SERVICE MANUAL
Advertisement
Table of Contents
